User Manual

X 4
5
1
3
4
2
6
User manual
9
KSWAW22
kross-studio.com
REPLACING THE BATTERIES
When turning on your watch winder, if the LED
button flashes once every 2 seconds, it means that
you have to change the batteries.
To replace the batteries, proceed as follows:
1. Remove the watch support (1) by unclipping
it in line with the winding case.
2. Using the Kross Studio key supplied with
your watch winder (6), remove the central
screw (3) by turning the key anticlockwise.
3. Once unscrewed, carefully remove the
winding case (4).
4. Insert 4 Lithium/Alkaline AA 1.5 (LR6)
batteries in their designated location (5),
beware the polarity (check the markings).
5. Replace the winding case carefully
respecting the central shape of the structure.
6. Replace the central screw (3) with the
Kross Studio key (6) while holding the winding
case in place.
7. Press the ON/OFF LED button (2) to check
that the device is recharged and can start a
new cycle. Make sure the ON/OFF LED blinks
4 times after the ON/OFF button is released,
meaning that the batteries are fully charged.
Note: The cycle will only start with the presence of a watch on the support.
We recommend to remove the batteries if you do not use your case for a long time.