Quick Start Guide

connection to another device, the battery will drain quickly. To
avoid losing
power during a data transfer, always use these apps after fully
charging the
battery.
Charging with the charger
Connect the USB cable to the USB power adaptor, and then plug the end of
the USB cable into the multipurpose jack.
Connecting the charger improperly may cause serious damage to the device.
Any damage caused by misuse is not covered by the warranty.
The device may be used while charging; in that case charging time is
prolonged.
If the device receives an unstable power supply while charging, the
touchscreen may not function. If this happens, unplug the charger from the
device.
While charging, the device and the charger may heat up. This is normal and
should not affect the device’s lifespan or performance. If the battery gets
hotter than usual, the charger may stop charging.
If the device is not charging properly, take the device and the charger to a
Digicom mobile Service Centre.
After fully charging, disconnect the device from the charger. First unplug the
charger from the device, and then unplug it from the electric socket.
To save energy, unplug the charger when not in use. The charger does not
have a power switch, so you must unplug the charger from the electric socket
when not in use to avoid wasting power. The charger should remain close to
the electric socket and easily accessible while charging.
Installing a SIM-card
Insert the SIM or USIM card provided by the mobile telephone service
provider.
1. Open the cover of the SIM-
card.
2. Insert SIM-card with contacts facing down as shown in the picture.
3. Push on the SIM-card into the slot to fix it.Attention!Do notinsert
thememorycard in slotfor the SIM
card. If the
memory card stuck in the slot for SIM-card, take the device to service center
Sigma mobile for its safe removal. Be careful not to lose the SIM-card and do
not let others use it. Digicom mobile is not liable for any damages or
inconvenience caused by lost or stolen cards.