Manual

IV. The Krieghoff Model Group 1
General instructions for use - Krieghoff PLUS, ULTRA, CLASSIC, HUBERTUS Page 8
N
N
o
o
t
t
e
e
:
:
• You must be absolutely certain that any firearm is unloaded before attempting to assemble or disassemble it.
• The gun must be uncocked before you assemble or disassemble it.
• Always use snap caps when dry-firing the gun.
• Never dry-fire the gun with the top lever in its open position. This may cause damage to the automatic hammer safety.
1. Assembly and Disassembly
Assembly
Putting the barrels on the receiver:
Pull the extractor out as far as it goes to prevent the receiver from touching the extractor legs and damaging them in the
process of putting the barrels on.
Grasp the barrels (see illus. 1) with one hand just in front of the monoblock with the muzzle facing down and hold the receiver
and buttstock in the other hand.
Line up the barrels with the receiver (do not cant the barrels) and engage the cutout of the front barrel lug at an angle as
shown (see illus. 1) onto the pivot of the action making sure it is fully seated.
With a tight fit the seating of the action might be easier by bracing the muzzle of the barrels between your legs.
Pivot the action and buttstock towards the barrels and at the same time keep the top lever fully pushed open.
Putting on the forearm:
Position the rear surface at a slight angle against the pivot of the action (see illus. 2 and 3). Then press the forearm firmly up
into the latched position against the barrels. Make sure that the latch engages fully.