Inc. Integrated Transport & Processor Owner's Reference

KPS-30i INPUT AND OUTPUT DETAILS

This is a description of the inputs and outputs of the KPS-30i. Please

contact your KRELL dealer or the KRELL staff for assistance ff there are any

questions not covered in this Reference. Please refer to the KPS-30i Typical

System Setup illustration on page 16.

CAUTION: When making connections to this component or any other, make sure

the power amplifier is OFF and the preamplifier is in the MUTE or STANDBY

mode.

ANALOG OUTPUT CONNECTIONS

The KPS-30i is equipped with two analog output configurations: Single-ended

via RCA connectors, and balanced via XLR connectors. If your preamplifier has

high level balanced inputs, we recommend the balanced outputs be used. There

are considerable sonic benefits to be gained with use of the balanced format.

The XLR pin configuration is described below.

Pin I Ground

Pin 2

Non-inverting {0

°)

Pin 3

Inverting ( 180

°)

The left and right channel RCA and balanced outputs are labeled on the back

panel. Care should be taken that the correct left/right orientation is

maintained.

NOTE: These two outputs can be used to simultaneously feed different systems,