Instructions / Assembly

www.kregtool.com
800.447.8638
Fig. 1
Production Stop
Top Trak
Workpiece
Lens
Stop arm
Knob
Fig. 2
The Production Stop measures and records the distance
between the end of the board and the saw blade,
drill bit or router cutter. This allows you to easily cut
multiple pieces of stock to the exact same length.
Cutting numerous pieces to the exact length without
measuring is easy. Gently press the end of the
board opposite the blade against the side of the stop
arm as shown in figure 1
.
The Production Stop can be secured anywhere
along the trak and can be easily lifted off the top
of the trak and repositioned on the opposite side
of the blade.
Tape
Miter Saw
Production Stop
Shop Made Table
Workpiece
ABOUT THE LENS
Our stops feature two adjustable
lens cursors similar to the lens on a quality
tablesaw rip fence. The lens is a clear
material except for a red line (cursor) on
the bottom of the lens as shown in figure 3.
The lens is adjustable to fine-tune the stop
and is secured in place with the Lens Screw.
Each lens can be set independently to read
accurately off of either side of the blade.
The red line cursor makes it easy
to read the tape lines and fine-tune the
stop when compensating for blade thickness
variations or a tape that is not perfectly
positioned.
Please note that when placing the self-adhesive
tape onto the track, the tape must be placed 3/8"
CLOSER TO the saw blade to allow the Lens
to function properly as shown in figure 4
.
Fig. 3
Fig. 4
Lens
24
Red Line
Cursor
Stop Arm
Lens
Slot
Lens
Scre
w
2324
Read Tape Here
3/8" off-set
Red Line
Cursor

FT4112
















