User Manual

Assembly
2
Turn the Drill Guide counterclockwise and
remove it from the Base. Insert the 35mm
Concealed Hinge Bit into the Drill Guide and
slide the Stop Collar onto the bit shaft until it
is seated on the shaft shoulder. Tighten the
set screw with the Hex Wrench. Set the Drill
Guide/35mm Bit aside.
Consult your hinge manufacturer’s
instructions for the distance from the edge of
the door to the edge of the 35mm hinge-cup
hole. Using a at-blade screwdriver, turn the
Edge Indexers so the appropriate dimension
aligns with the line on the Base. The edge-
of-door to edge-of-hole dimension usually is
given in millimeters. For a dimension given as
a fraction of an inch, see the cross-reference
table directional.
Stop Collar
Edge indexer
WARNING The drill bit is sharp. Keep the cap on
the bit until you are ready to drill. Wear gloves when
handling an unprotected bit.
ATTENTION The drill bit included with this jig
is a custom length with a shoulder for accurately
positioning the Stop Collar. Use only a Kreg 35mm
Concealed Hinge Bit as a replacement.
Dimension given
as fraction of an inch
Set Edge Indexers
to millimeter
dimension
1/8" 3mm
5/32" 4mm
3/16" 5mm
1/4" 6mm
Shaft shoulder
!
!