Installation Guide

1
10
9
11
12
Place the washer (1) underneath the
flange of the pop-up body (2). Slide the
pop-up body (2) down through the
drain hole on the vessel or basin sink.
From the underside of the sink, slide the
washer (3) against the bottom of the
vessel or basin sink, thread on the
coupling nut (4) and tighten. Do not
overtighten.
After installing the faucet, remove the
aerator (G) with the included aerator
key (H). Turn the water on for 30
seconds to remove any debris.
Reassemble the aerator (G ).
2
3
4
1
Slide the nut (6) over the tail pipe (7).
Place the washer (5) into the nut and
tighten. Do not overtighten.
G
H
279
10 31/32”
Minimum distance 90mm
Cold Water
Max35
217
8 17/32”
Max1 3/8”
8
Step 5: Flush faucet
Step 4: Install Press pop-up assembly - continued
2
3
4
1
6
7
5