Installation Guide

6
Step 3: Secure faucet
C
B
E
B
Secure faucet body (B) by
tightening the set screw with
2.5mm hex wrench (E)
Step 3: Connect waterlines to main valve
Thread hot & cold waterlines
(D) onto angle stops. Tighten
with adjustable wrench until
snug. Turn on the angle stops
and check for leaks (DO NOT
TURN FAUCET ON)
Installer Tip: Use two
wrenches when securing
waterlines to angle stops
to prevent kinking, as
shown in picture
D
D
Hot
Cold