Installation Guide

7
Step 3. Secure mounting hardware
Adjust direction of faucet body (2)
so that handle is on right side of
faucet. Tighten mounting nut (3C)
until snug. Tighten mounting
screws (3D) to nut with Phillips
screwdriver until snug.
Step 4. Connect waterlines
Connect hot and cold copper lines
(4) to angle stops. Tighten both
ends of waterlines with a wrench
until snug. Turn on hot and cold
angle stops and check for leaks.
4
NOTE: Please make sure filter
washers are installed before
connecting to the main valve.