Installation Guide

10
9
11
12
13
Hexagon Nut
Hot
Water
Cold
Water
11
Close
Open
Left
Hot Water
Push
25°
90°
12
13
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly, take
the following corrective steps:
Leakage under the handle.
PROBLEM CAUSE ACTION
Bonnet nut (8) has
come loose.
Remove the cover button (12). Loosen the
screw (11) with the hex wrench (18).
Remove the handle (10). Unscrew the cap
(9) (by hand only). Tighten the bonnet nut
(8) with an adjustable wrench.
Aerator drips or has
inconsistent water flow
pattern
Aerator (1) is dirty or
not seated properly
Unscrew aerator (1) with a coin and clean
out debris.
Water will not shut off
completely.
Cartridge may need to be
adjusted or replaced.
Remove the cover button (12). Loosen the
screw (11) with the hex wrench (18).
Remove the handle (10). Unscrew the cap
(9) (by hand only). Loosen the bonnet nut
(8) with an adjustable wrench. Remove
the cartridge (7). Check for cracks.
There is a low flow of water.
The filter washers in the
hose connectors are dirty.
Turn off the water supply at the water
valves and unscrew the hose connectors
from the water supply lines. Clean the
filter washers in the water lines with hot
water, removing any debris or calcium
build up.
9