Installation Guide

Pull the hose assembly
out of the spout
and remove the spray head (A) by
unscrewing it from the hose in a
counterclockwise direction. Be sure to hold
the end of the hose down into the sink
and turn the faucet on to the warm
position where it mixes hot and cold water.
Flush the water lines for one minute. This
flushes away any debris that could cause
damage to internal parts. Check for leaks.
Retighten any connections if necessary,
but do not overtighten. Reinstall the spray
head (A) by hand tightening it back onto
the spray hose.
After installation is complete, turn on the
hot and cold water supplies. Check for
leaks.
NOTE: Please make sure washer is
installed attaching spray head to hose.
A
Step 5: Flush faucet
8