Installation Guide

Trouble-Shooting

If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps:

Leakage under faucet handle

The bonnet nut (15) has come loose

and the ring on the cartridge is dirty

or damaged

Tighten the bonnet nut. Clean or replace

the cartridge

Leaking between spray head

and the hose

Spray head (1) may be loose or

washer (3) is not seated correctly

in the hose connection.

Tighten spray head (A) by hand until snug.

Make sure washer (3) is seated correctly

PROBLEM CAUSE ACTION

The water pressure is low

Flow regulator (13) may be clogged

with debris.

Loosen set screw (18) with hex wrench.

Remove handle and unscrew the cap (16)

by hand. Unscrew the bonnet nut with an

adjustable wrench. Remove the cartridge

(14,15). Clean the flow regulator.

Waterlines may be clogged

Turn off the water supply at water valve

and unscrew the hose connectors from

water supply lines. Clean the screen in

the water lines with hot water, removing

any debris or calcium build up.