Installation Guide

Step 7. Flush and check for leaks

Pull hose assembly out of spout

and remove spray head by

unscrewing from hose in a

counterclockwise direction.

Hold the end of the hose down

into the sink and turn the faucet on

to the warm position. Flush water

lines for one minute to flush away

any debris. Check for leaks.

Re-tighten any connections if

needed. Do not overtighten.

Reinstall spray head by hand

tightening it back onto the spray

hose. After installation is completed,

turn on the hot and cold water

supplies to check for leaks.

Step 8. Flow regulator replacement

This faucet ships with a 1.8 GPM

washer installed. Remove the

1.8 GPM washer and replace with

the 2.2 GPM washer.

To switch the flow rate of the faucet:

1. Unthread the spray head and

remove the 1.8 GPM washer (1).

2. Replace the washer with the 2.2

GPM washer (2) provided.

NOTE: In compliance with CEC standards, this faucet is designed with a 1.8 gpm

flow rate. At your discretion, you may modify the product with the included 2.2

gpm restrictor. Please note that doing so will remove the capability of this product

to meet specifi c low- flow standards. Kraus is not liable for any alterations made to

the product post-sale, and highly advises that you consult with your local or

statewide plumbing enforcement agency prior to any modifi cation.