Installation Guide

Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly,
take the following corrective steps:
Leakage under the handle.
PROBLEM CAUSE ACTION
Bonnet nut (12) has
come loose.
Remove the index (14.3). Loosen set screw
(14.2) with hex wrench (14). Remove the
handle (14.1). Unscrew cap (13)
(by hand only). Tighten bonnet nut (12)
with an adjustable wrench
The aerator has an irregular
or reduced water flow.
The aerator is dirty or
misfitted.
Remove the aerator and check for
debris. Ensure that the rubber washer is
properly installed.
The water pressure is low.
The connector underneath the
deck is clogged with debris.
The aerator is clogged.
The screen filters in the
hose connectors are dirty.
Turn off the water supply and disconnect
the connector / aerator. Unscrew the
connector / aerator and clean under
running water. Screw the connector /
aerator back. Test water flow. If water
pressure is still low then replace the
connector / aerator.
Turn off the water supply at the water
valves and unscrew the hose connectors
from water supply lines. Clean the
screens in the water lines with hot water,
removing any debris or calcium build up.
11