Installation Guide

Step 8. Flush and check for leaks
Pull hose assembly out of spout
and remove spray head by
unscrewing from hose in a
counterclockwise direction.
Hold the end of the hose down
into the sink and turn the faucet on
to the warm position. Flush water
lines for one minute to flush away
any debris. Check for leaks.
Re-tighten any connections if
needed. Do not overtighten.
Reinstall spray head by hand
tightening it back onto the spray
needed. After installation is completed,
turn on the hot and cold water
supplies to check for leaks.
1
2
11
Step 7. Connect the waterlines
Thread the nut (1) on the supply line
onto the outlet of the water supply
valve (2) and tighten with wrench.
Do not overtighten.
NOTE: Please make sure filter
washers are installed before
connecting to the main valve.