Installation Guide

10
9
11
12
13
Hexagon Nut
Hot
Water
Cold
Water
Close
Open
Left
Hot Water
Push
25°
90°
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly,
take the following corrective steps:
Leakage under the handle.
PROBLEM CAUSE ACTION
Bonnet nut (7) has come
loose.
Remove the index (11). Loosen set screw
(10) with hex wrench (21). Remove the
handle (9). Unscrew cap (8) (by hand only).
Tighten bonnet nut (7) with an adjustable
wrench.
Water will not shut off
completely.
Cartridge may need to be
adjusted or replaced.
Remove the index (11). Loosen set screw
(10) with hex wrench (21). Remove the
handle (9). Unscrew cap (8) (by hand
only). Loosen the bonnet nut (7) with an
adjustable wrench. Remove the cartridge
(6). Check for cracks.
The aerator has an irregular
or reduced water flow.
The aerator is dirty or
misfitted.
Remove the aerator and check for debris.
Ensure that the rubber washer is properly
installed.
There is a low flow of water.
The filter washers in the
hose connectors are dirty.
Turn off the water supply at the water
valves and unscrew the hose connectors
from the water supply lines. Clean the
filter washers in the water lines with hot
water, removing any debris or calcium
build up.
10