Installation Sheet

3
Make sure to check off that you have all of the following items
Prior to Installation:
· Make sure that you have all necessary parts by checking the parts list. If any part is missing
or damaged, please contact Kraus Customer Service at 800-775-0703 for a replacement
· Inspect the sink prior to installation to make sure that it has not been damaged or during
shipping
· Use the cut-out template provided by Kraus
· Observe all plumbing and building codes according to your state requirements
· Turn off the cold and hot water at the angle stops and turn on the old faucet to release and
built up pressure
· Flush angle stops to release any debris prior to installation
· Pre-drilled hole size requirement: 1 3/8" (min) - 1 1/2" (max)
· Max countertop thickness: 1 1/2"
Kitchen Sink - KHT400-33
Kitchen Faucet - KPF-1610SS
Cut-Out Template
Undermounting Hardware
Top Mount Hardware
Bottom Grid - KBG-T400-33
Drain - ST-1
The step-by-step guidelines in the installation instructions are a general reference for installing a
Kraus Sink. Should there be any discrepancies, Kraus cannot be held liable. It is recommended to
install all Kraus products by hiring a licensed professional.