Installation Manual

8
4. Install anchors
NOTE:
• Please check epoxy directions for curing time
• Please tap brass nut anchors lightly with hammer
• Flip countertop over and place on a foam pad for protection. Use cutout
template to mark the anchor placement on the countertop. Drill 5/16”
diameter x 3/8” deep hole in countertop
• Place epoxy in the drilled hole. Insert brass nut anchors into the drilled
hole and wait until the epoxy cures
Clip Location
12.4” (315mm)
15.6” (395mm)
Rim of Lavatory
Cut Along This Line
Clip Location
12.4” (315mm)
15.6” (395mm)
Rim of Lavatory
Cut Along This Line
Clip Location
Rim of Lavatory
Cut Along This Line
11.61” (295mm)
17.7” (450mm)
Model No. KCU-251
Allow a minimum of 4.5” (114.3mm)
from wall for faucet placement
clearance before cutting
NOTE: When plotting template
full size: Make sure horizontal
and vertical dimensions match
the dimensions labeled in the
template
12.9” (328mm)
19.9” (506mm)
Clip Location
Rim of Lavatory
Cut Along This Line
Clip Location
Rim of Lavatory
Cut Along This Line
11.61” (295mm)
17.7” (450mm)
Model No. KCU-251
Allow a minimum of 4.5” (114.3mm)
from wall for faucet placement
clearance before cutting
NOTE: When plotting template
full size: Make sure horizontal
and vertical dimensions match
the dimensions labeled in the
template
12.9” (328mm)
19.9” (506mm)
Clip Location
Rim of Lavatory
Cut Along This Line