I N S TA L L AT I O N MA N UA L Aplos Single Lever Vessel Faucet KEF-15300 www.kraususa.com I toll free: 1.800.775.0703 I © 2013-2014 Kraus USA Inc.
Thank you for purchasing Kraus We would like to take this opportunity to thank you for your business with Kraus USA. It is our sincere hope that you are completely satisfied with your experience. We welcome any questions or comments you may have, and will be glad to assist you in the future. For more information about Kraus products, please visit our website at: www.kraususa.
Prior to Installation: • Make sure you have all necessary parts by checking the diagram and parts list.
Replacement Parts 1B 1A 11 1. (A) Index Button 2 3 4 (B) Set Screw 2. Metal Handle 5 3. Cartridge Cover 4. Locking Nut 5. Cartridge 9 10 6. Faucet Body 6 7. Rubber Washer 8. Mounting Hardware (A) Rubber Washer (B) Metal Washer (C) Mounting Nut (D) Mounting Screws 9. Aerator 12 10. Aerator Key 11. Hex Wrench 7 12.
Faucet Installation Procedure 161mm (6.33”) Ø35mm (1.37”) G1/2 Installer Tip: Shut off main water supply before installing new faucet max30 (1.18”) 297mm (11.69”) 248mm (9.76”) 58mm (2.
Step 1 Step 2 Step 1: Remove mounting hardware Remove the mounting screws (8D), mounting nut (8C), metal washer (8B), and rubber washer (8A) from the mounting pipe 8A 8B Step 2 8C 8D Step 5 Step 2: Install hot & cold waterlines Step 3 Place faucet on a soft cloth, spout facing up.
tep 3 8A 8B 8C 8D 8C 8D Step 3: Install faucet 9 Install faucet through 1-3/8” predrilled hole10 in countertop. Attach rubber washer (8A), metal washer (8B), mounting nut (8C), and mounting screws (8D) on the threaded mounting pipe. Tighten mounting nut (8C) until snug.
p4 Step 4: Connect waterlines to main valve Connect flex water supply lines to angle stops and tighten with adjustable wrench. Turn on both hot and cold main valve Apply pipe tape (optional) Step 5: Flush faucet Step 5 9 10 After installing faucet, remove aerator (9) with included aerator key (10). Turn water on for 30 seconds to remove any debris.
Trouble - Shooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: PROBLEM CAUSE ACTION 10 Leakage under the handle Locking nut (4) has come loose Hexagon Nut 9 11 12 13 Remove handle index button (1a). Loosen set screw (1b) with hex wrench (9). Remove metal handle (2). Unscrew cartridge cover (3) (by hand only).
Codes/Standards Applicable: NSF/ANSI 372 GREEN LEAD FREE IA P MO R& T NSF/ANSI 61 ASME A112.18.1M 1.5GPM 5.7L/min maximum TM Water Efficiency KRAUS LIMITED LIFETIME WARRANTY This product has been manufactured and tested to the highest quality standards by Kraus USA Inc. (“Kraus”). We offer our customers thoughtfully crafted fixtures & accessories, engineered for enduring performance over years of use. WHO IS COVERED BY THE WARRANTY This warranty extends to the original purchaser only.
C. Kraus recommends installing all Kraus products with a licensed, professional plumber. Kraus will not be held responsible for any damage or product failure due to improper installation, misuse, or failure to use a licensed professional. Please read your care and maintenance documentation to determine the limits of proper use. D. Commercial use will automatically void this warranty. E. This warranty is not applicable to Kraus products purchased from an unauthorized seller.
www.kraususa.
