User`s manual
5
Manual
www.kraun.com
3. Ethernet jack – this is the place to plug in the RJ45 Ethernet cable. When the Ethernet link is ok, the
Ethernet indication LED on the front side will be blue light.
4. Reset button – this is the button to reset the IP Camera to default factory settings. You need to use a
small stick like pencil or tooth stick to press the reset button for more than 3 seconds to enable the
reset function. Usually when you forgot the administrator account, you will probably need to do this
reset action to reset to the default factory settings. Please refer to section 3.15 for more details.
5. Antenna jack(for Cam(w)) – this is the place to hold the wireless antenna. The antenna must be
plugged to let the 802.11 b/g wireless work.
6. WPS button – for WPS(WiFi protected setup) operation. When doing the WPS procedure, the Ethernet
indication LED(blue) will be on and o every 0.3 second until WPS succeeded or failed
Figure 2-2: Major components in the back panel
2.2. Quick installation and usage
There are only three things that you need to do to see the video from the IP Camera.
1. Connect the IP Camera to the home/oce network.
2. Install the KraunView software on the notebook/PC.
3. Key in the ID/password of the IP Camera(from the ID/Password card) on the KraunView, and then you
can see the video.
(KW.08)