User`s manual
4
Manual
www.kraun.com
2. HARDWARE DESCRIPTION AND QUICK
INSTALLATION/USAGE
The IP Camera is designed to be very easy to install and use. First, let’s see the major components of the IP
Camera products.
2.1. Major hardware components.
The major components on the front panel of the IP Camera products are the built-in microphone, lens and
LEDs :
1. Microphone – for receiving the audio/voice. Eective distance is about 5 meters.
2. Lens – the focus of the lens is xed, you do not need to spend time to adjust the focus, the eective
focus range is from 30cm to innity.
3. Micro-SD card slot – for inserting the micro SD-Card. (support up to 16G bytes)
4. SD card access LED(yellow) – the indication of SD card access. When the SD card is inserted and
mounted, the led will be on. When the camera is doing video recording, the led will be blinking.
5. Status indication LED (red) – this LED is to indicate the Internet connection status. When the Internet
connection is connected, the LED will be constant red light. If there is any Internet connection
problem, the LED will be blinking red light.
6. Ethernet indication LED (blue) – this LED is to indicate if the Ethernet link is ok and packet trac is
sending/receiving. When the Ethernet cable is connected, the LED is constant blue light. When there
is packet sending/receiving, this blue LED is blinking.
Figure 2-1: Major components in the front panel
The major components on the back panel of the IP Camera products are the bracket screw jack, power
jack, Ethernet jack and reset button:
1. Bracket screw jack – this is the position to screw in the bracket of the IP Camera. With the bracket, you
can put the IP Camera on the desk, on the wall or on the ceiling.
2. Power jack – this is the place to plug in the power adaptor. The power needed for this IP Camera is
5V/1.0A, please make sure you are using the correct power adaptor.