K2160TST 10A Manual

20 21
High-pressure hose and spray device
The high-pressure hose and spray device which are part of the K 2000-series
equipment, are made of high quality material and engineered to conform with
the operating conditions of the high-pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void
if spare parts of third-party providers are used! The high-pressure hose
and spray device must be connected in a pressure-tight manner
(without leakage).
The high-pressure hose may not be driven over, pulled excessively, or
twisted. The high-pressure hose may under no circumstances be pulled
over sharp edges. Defective high-pressure hoses must not be repaired
(acc. to DIN 20022) but have to be replaced by new hoses approved by
the manufacturer.
Prior to putting the high-pressure cleaner into operation make sure
that all safety instructions be observed.
The high-pressure cleaner must be operated in horizontal
position!
It is imperative that safety instructions be observed during
use of the high-pressure cleaner.
Neither set up or operate the K 2000-series in rooms where there is
a risk of fire or explosion nor put it into puddles. Do not use the high-
pressure cleaner under water. If, none the less, the high-pressure
cleaner is operated in a hazardous area, the applicable safety
regulations are to be observed.
2. Move high-pressure cleaner to the job
site. The K 2000-series is a movable
high-pressure cleaner with sturdy
trolleys ideally suited for difficult
terrain and stairs.
1. For high-pressure cleaners with hose
drum the enclosed hand crank mus be
applied prior to first operation. For this
purpose, please set up the high-pres-
sure cleaner. Plug the hand crank onto
the hexagon and attach it with the
enclosed screw and washer.
Putting into operationFunctional details