K1152TST Manual

22 23
8. Check water inlet filter for cleanliness
prior to putting the high-pressure
cleaner into operation.
Manually unscrew plug-in coupling.
Take out the water inlet filter using
needle nose pliers and thoroughly
rinse it with clear water and clean
it with the other parts. If the sieve
is dirty, water can not get through
and pressure will not build up.
9. Connect water hose to water inlet
(minimum requirements; 5 m hose
length, cross-section ¾", 10 bar).
The high-pressure cleaner may
be
connected to a water mains (1-10 bar
pre-pressure) with either cold or hot
water (up to 60 °C).
Check the water inlet sieve for damage. Do not operate the
high-pressure cleaner without or with a damaged filter.
Be careful when using hot water!
When running your high-pressure cleaner with hot water of 60 °C raised
temperatures occur. Do not touch the metal parts of the high-pressure
cleaner without safety gloves!
12. Switch on high-pressure cleaner with
opened safety trigger gun. Bleeding
of the high-pressure cleaner: Pull and
release trigger of safety trigger gun
several times. Start cleaning task.
11. Connect to circuit (see technical data).
13. When using the dirtkiller lance make
sure that lance points downward when
starting.
15. The K 1152-series units are equipped
with a support for the safety trigger
gun with lance during breaks.
Operate high-pressure cleaner in
horizontal position.
Putting into operation Putting into operation
14. Adjust operating pressureinfinitely
using the rotary handle. The maximum
pressure is factory-set.
10. Each time check oil level at the oil
dipstick prior to putting the high
pressure cleaner into operation.
(Take care that cleaner is in horizontal
position!) Oil level must reach until the
upper edge of marking "OK“.
Do not touch the mains plug or any live parts with wet or moist hands.