Manual
18 19
When carrying the K 1050 TS/TST, make sure to bear in mind the
weight of the high pressure cleaner (see technical data).
The high pressure cleaner must be operated in
horizontal position!
Neither set up or operate the K 1050 TS/TST in rooms where there is
a risk of fire or explosion nor put it into puddles. Do not use the high
pressure cleaner under water. If, none the less, the high pressure
cleaner is operated in a hazardous area, the applicable safety
regulations are to be observed.
1. Use the supplied screws to fasten the
lower cable retractor of the power
supply cable in the place provided on
the frame.
3. Move high pressure cleaner to the job
site. The K 1050 TS/TST is a movable
high pressure cleaner with sturdy
trolleys ideally suited for difficult
terrain and stairs.
4. Owing to its light weight and handy
size, the K 1050 TS/TST can be easily
carried by two persons.
Putting into operation Putting into operation
5. For high pressure cleaners with hose
drum, however, it must be uncoiled
completely. For high pressure cleaners
without hose drum the high pressure
hose included in the scope of the
delivery must be screwed with the
pump outlet in a tight and pressure
tight manner. Unwind high pressure
hose straight and without nooses.
The high pressure hose may leave
signs of abrasion on some floors.
Alternatively, please also find
non-marking high pressure hoses
in our range.
2. For high pressure cleaners with hose
drum the enclosed hand crank mus be
applied prior to first operation. Please
set up the high pressure cleaner. Plug
the hand crank on to the hexagon and
attach it with the enclosed screw and
washer.
6. Tightly screw together high pressure
hose and safety trigger gun.
8. After insertion of the lance, release
retaining sleeve and make sure that the
lance is in a secure position.
Grease quick release nipple regularly
using acid-free grease.
7. First pull back the retaining sleeve
of the safety trigger gun, then
insert lance into the plug coupling
sconnection of the safety trigger gun.
Prior to insertion, check plug coupling connection of lance for
cleanliness (sand, dirt ..) and use clear water to clean, if necessary.
Impurities may damage the sealing in the plug coupling.