Manual

16 17
When carrying the K 1050 P, make sure to bear in mind the weight
of the high pressure cleaner (see technical data).
Do not place the K 1050 P on rough surface because the
high pressure cleaner tends to vibrate during operation.
Neither set up or operate the K 1050 P in rooms where there is a risk of
fire or explosion nor put it into puddles. Do not use the high pressure
cleaner under water. If, none the less, the high pressure cleaner is
operated in a hazardous area, the applicable safety regulations are
to be observed.
1. Carry the K 1050 P to its place of
operation. When parking the high
pressure cleaner make sure that the
four rubber buffers stand on a safe
support.
Putting into operation Putting into operation
2. Unwind high pressure hose straight
and without nooses. When using high
pressure hose extensions take care
that the max. length of 20 m is not
exceeded!
3. Plug screw high-pressure hose included
in scope of delivery at pump outlet and
tightly screw pressure-tight.
6. After insertion of the lance, release
retaining sleeve and make sure that the
lance is in a secure position.
Grease quick release nipple regularly
using acid-free grease.
5. First pull back the retaining sleeve
of the safety trigger gun, then
insert lance into the plug coupling
sconnection of the safety trigger gun.
4. Tightly screw together high pressure
hose and safety trigger gun.
Putting into operation
Prior to insertion, check plug coupling connection of lance for
cleanliness (sand, dirt ..) and use clear water to clean, if necessary.
Impurities may damage the sealing in the plug coupling.
Accessories may only be connected to a Kränzle-approved trigger gun
with safety catch.
The high pressure hose may leave signs of abrasion on some floors.
Alternatively, please also find non-marking high pressure hoses in our range.