Manual

Inspection report for HP cleaners
Type plate (on hand)
Operating manual (on hand)
Protective covering, -device
Pressure line (tightness)
Pressure gauge (function)
Float valve (tightness)
Spraying device (marking)
HP-hose/ connector (damage, marking)
Safety valve opens at 10% / 20% excess
Pressure reservoir
Heating oil line (tightness)
Solenoid valve (function)
Thermostat (function)
Flow controller (function)
Power cable (damage)
Power plug (damage)
Protective conductor (connected)
Emergency Off Switch (function)
On/Off-switch
Water quantity safety device (function)
Used chemicals
Allowed chemicals
High-pressure nozzle
Operating pressure ............bar
Cutting-off pressure.............bar
Smoke spot number...........acc. to Bacharach scale
CO²-value...................% CO²
Efciency rating.............%
Conductor resist. not exceeded / value:
Insulation
Leakage current:
Gun locked
Inspection report on annually carried out Labour Safety Inspection (UVV) according to the Guide-
lines for Liquid Spray Equipment. (This inspection sheet serves as proof for the completion of the
retest and must be kept carefully!) Kränzle-Test Stamp Mark: Order Number UVV200106
Scope of inspection: ok yes no repaired
Inspection data determ. value set value
Owner:
Address:
Type therm:
Serial no.:
Rep.-order-no.:
The appliance was checked by an expert according to the Guidelines for Liquid Spray
Equipment, the defects found have been rectied so that the Labour Safety can be conrmed .
The appliance was checked by an expert according to the Guidelines for Liquid Spray
Equipment. The Labour Safety cannot be conrmed unless the defects found are rectied by
repair or replacement of the faulty parts .
The next retest according to the Guidelines for Liquid Spray Equipment has to be carried out
by: Month Year
Place, Date Signature
Inspection result (tick)
58