Manual
Care and Maintenance
Care and Maintenance
Care and maintenance is required to keep the machine in good working order, and
to allow you to enjoy the machine for as long as possible.
IMPORTANT!!!
Always remove the plug before working on the machine!
Only use original Kränzle spare parts
What to do!
- Weekly, or after approx. 40 hours of operation
Check the oil level of the high pressure pump. (see page 13)
If the oil level is too low, add oil until the oil level is between the two markings on
the oil measuring rod.
Change the oil (see page 19) if it has a grey or whitish appearance. The oil
should be disposed of responsibly.
Check the lter in front of the oat valve in the water tank and the fuel lter
in front of the solenoid valve. Clean the lters if necessary.
- Yearly, or after approx. 500 hours of operation
Desulphurise and decarbonize the heating coil.
Check if the heating coil is calcied (see page 20).
Check the oil burner and ignition system.
Clean the oil nozzle, oil lter, solenoid valve and lter, clean and adjust the
ignition transformer, ignition cable and ignition electrodes and replace defective parts.
Change the oil
18
Changing the oil
To do this, take the oil drainage hose (1) con-
nected to the oil drain screw, from the inside
of the machine and open the red oil ller
cap on the top side of the black oil reservoir.
Open the cap at the end of the hose. Drain
off the oil into an oil pan and dispose of it
responsibly. Close the end of the hose.
Rell with oil.
1