User's Manual

Kramer Electronics Ltd.
VM-3DT - Connecting the VM-3DT
5
Connecting the VM-3DT
Always switch off the power to each device before connecting it to your
VM-3DT. After
connecting your
VM-3DT, connect its power and then switch on the power to each device.
To connect the VM-3DT as illustrated in the example in Figure 2:
1. Connect the HDBT input source (for example, TP-580T) to the HDBT IN connector .
2. Connect the three HDBT outputs to three HDBT receivers (for example, TP-580R
devices).
3. Connect the 5V DC power adapter to the power socket unit and then connect the
adapter to the mains electricity (not shown in
Figure 2).
The ON LED lights .
Figure 2: Connecting to the VM-3DT Rear Panel