User's Manual

Kramer Electronics Ltd.
VM-3DT - Defining the VM-3DT 1:3 HDBT Distributor
4
Defining the VM-3DT 1:3 HDBT
Distributor
This section defines the VM-3DT.
Figure 1: VM-3DT 1:3 HDBT Distributor Front Panel
#
Feature
Function
ON LED Lights when the unit receives power.
PROGRAM Mini USB
Connector
Use to send serial commands, see Protocol 3000 on page 16.
Connect to a PC to perform firmware upgrades (via K-Upload)
and work
with the EDID Designer.
K-Upload and EDID Designer can be downloaded from our Web site at:
www.kramerav.com/support/product_downloads.asp.
EDID SETUP Button Press to capture the input EDID or select the default EDID, see
Acquiring an EDID on page 9.
ACTIVE INPUT LED
Lights when an HDMI signal is embedded on the HDBaseT input
HDBT LINK LEDs
IN
Lights when a link is established with the transmitter.
OUT
Lights when a link is established with the receiver (from 1 to 3).
OUTPUTS CONNECTED
LEDs
Lights when an acceptor (sink) is detected on the HDBaseT receiver
connected to the output (from 1 to 3)
INPUT HDBT Connector
Connects to the HDBT source, for example TP-580T.
HDBT OUT Connectors
Connect to an HDBT acceptor (from 1 to 3), for example TP-580R.
SETUP 8-way DIP-switches Used to set the IR and RS-232 command behavior, see
Setting the
DIP-Switches for Routing on page 6.
SETUP 4-way DIP-switch For future use.
5V DC Connector
Connects to the 5V DC power supply.