User's Manual

Kramer Electronics Ltd.
VM-3DT - Protocol 3000
24
EDID Handling Commands
Additional EDID data functions can be performed via a compatible EDID management
application, such as Kramer EDID Designer (see
www.kramerav.com/product/EDID%20Designer
).
Command
Description
CPEDID
Copy EDID data from the output to the input EEPROM
CPEDID
Functions
Permission
Transparency
Set:
CPEDID
End User
Public
Get:
-
-
-
Description
Syntax
Set:
Copy EDID data from the output
to the input EEPROM
#CPEDIDSPsrc_type,src_id,dst_type,dest_bitmapCR
Get:
-
-
Response
~nn@CPEDIDSPsrc_type,src_id,dst_type,dest_bitmapCR LF
Parameters
src_type – EDID source type (usually output): 0 (Input), 1 (Output), 2 (Default EDID)
src_id – for input source: 1 (Input), for output source: 0 (Default EDID source), 1 (Output 1), 2 (Output 2),
3 (Output 3)
dst_type – EDID destination type (usually input): 0 (input), 1 (output), 2 (default EDID)
dest_bitmap – bitmap representing destination IDs. Format: XXXX…X, where X is hex digit. The binary
form of every hex digit represents corresponding destinations. Setting ‘1’ indicates that EDID data is copied
to this destination. Setting ‘0’ indicates that EDID data is not copied to this destination.
Response Triggers
Response is sent to the com port from which the Set was received (before execution)
Notes
Destination bitmap size depends on device properties (for 64 inputs it is a 64-bit word)
Example: bitmap 0x0013 means inputs 1, 2 and 5 are loaded with the new EDID.
In this device, if the destination type is input (0), the bitmap size is 1 bit, for example bitmap 0x1 means the
input is loaded with the new EDID.
K-Config Example
Copy the EDID data from Output 1 (EDID source) to the Input:
“#CPEDID 1,1,0,0x1”,0x0D
Copy the EDID data from the default EDID source to the Input:
“#CPEDID 2,0,0,0x1”,0x0D