User Manual

Using the VM-24H

4. Press the EDID READ button to copy the EDID of the selected OUTPUT

to the inputs

6.4.2 Acquiring the Default EDID

While the EDID is being copied, the EDID SELECT and READ buttons

illuminate.

The new EDID is copied when both buttons no longer illuminate.

To reset to the default EDID

1. Connect the power supply.

, do the following:

2. Press the EDID SELECT button and set it to the Default EDID mode.

All the OUTPUT STATUS LEDs flash simultaneously.

3. Press the EDID READ button to copy the default EDID to the inputs

While the EDID is being copied, the EDID SELECT and READ buttons

illuminate.

The new EDID is copied when both buttons no longer illuminate.

6.4.3 Acquiring the Auto-mix EDID from the Connected Outputs

To acquire the Auto-mix EDID

1. Connect the power supply.

2. Connect the desired output display devices.

3. Enter the Auto-mix mode as defined in

Table 2.

All the OUTPUT STATUS LEDs light.

4. Press the READ button to copy the EDID of the selected OUTPUT to the

inputs

While the EDID is being copied, the EDID SELECT and READ buttons

illuminate.

The new EDID is copied when both buttons no longer illuminate.

1 If you want to cancel the EDID modification, wait for a few seconds without touching any button

2 The factory-default which is programmed into the VM-24H before it is shipped

3 The EDID acquired is a weighted average of all the connected outputs. For example, if several displays with different

resolutions are connected to the outputs, the acquired EDID supports all the resolutions, as well as other parameters included

in the EDID