User Manual

Using the VM-24H
9
9
6 Using the VM-24H
This section describes how to:
• Connect the VM-24H, see section
6.1
• Control the VM-24H via RS-232, see section
6.2
• Operate the VM-24H, see section
6.3
• Use the EDID button, see section
6.4
6.1 Connecting the VM-24H
To connect the VM-24H, as illustrated in the example in
Figure 2, do the
following
1
1. Connect
:
2
2. Connect the HDMI OUTPUT connectors
the two HDMI sources, for example, a DVD player and a set top
box, to the INPUT 1 and INPUT 2 connectors, respectively.
3
to up to 4 HDMI acceptors,
using Kramer HDMI copper cables. In this example
4
 OUTPUT 1 connector to acceptor 1 (for example, a plasma
display)
, connect the:
 OUTPUT 2 connector to acceptor 2 (for example, an LCD TV)
 OUTPUT 3 connector to acceptor 3 (for example, an LCD TV)
 OUTPUT 4 connector to acceptor 4 (for example, a plasma
display)
3. If required, connect a PC and/or controller to the RS-232 port (see section
6.2).
4. Connect the power cord to the mains electricity (not shown in
Figure 2).
5. If required, acquire the EDID (see section
6.4).
1 Switch OFF the power on each device before connecting it to your VM-24H. After connecting your VM-24H, switch on its
power and then switch on the power on each device
2 Using the Kramer HDMI copper cables
3 As required. Up to four outputs can be connected. Not all outputs need to be connected
4 Only connections from the first two acceptors and the last two acceptors are shown in
Figure 2