User Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VA-1VGAN EDID Capture
6
Figure 2: VA-1VGAN – Acquiring the EDID from the Display Device
5.2 Reconnecting the Projector
To reconnect the projector at a distance from the PC, as illustrated in the
example in Figure 3, do the following
1
:
1. Connect a VGA source (for example, a VGA computer graphics source) to
the INPUT VGA connector on the VA-1VGAN.
Turn on the VGA source only after connecting the VA-1VGAN,
so it can acquire the EDID properly
2. Connect the 5V DC power adapter to the power socket and connect the
adapter to the mains electricity
2
.
3. When installation is complete
3
, connect the OUTPUT VGA connector of
the VA-1VGAN to the projector, using the required cable length.
1 Switch OFF the power on each device before connecting it to your VA-1VGAN
2 If the PC can supply power to the unit via its VGA connector, the power supply is not needed
3 The EDID is transmitted to the PC via the VA-1VGAN, so the PC gets the EDID information even if the projector is
temporarily disconnected. When installing the display again at a distance, there is no need to reboot the PC