System Guide

Step 6: Control PA-120Z / PA-240Z via embedded web pages
RS-232
Protocol 3000
Baud Rate:
115,200
Stop Bits:
1
Data Bits:
8
Parity:
None
Change the volume of input 2 to -10 DB
#X-AUD-LVL 1,2,-10
TCP/IP Parameters
IP Address:
192.168.1.39
Maximum UDP Connections:
Unlimited
UDP Port #:
50000
Subnet mask:
255.255.000.000
Maximum TCP Connections:
Unlimited
TCP Port #:
5000
Default gateway:
192.168.0.1
Default Username / Password:
Admin / Admin
Full Factory Reset
Protocol 3000
Excluding ETH: use “#FACTORY” command and use “#RESET” to restore the factory default values.
Technical Specifications
PA-120Z
PA-240Z
Input:
1 unbalanced stereo on a 3.5mm connector
1 balanced stereo +4dBu/10kΩ on a 5-pin terminal block
Output:
1 balanced stereo line level on a 5-pin terminal block
1 stereo or 1 mono speaker output on a 4-pin large terminal block
Input Sensitivity:
Full power @ 0.3V (–10dBV)
Output Power:
2 x 60W @ 4Ω or 8Ω
1 x 120W @ 70V or 100V
2 x 120W @ 4Ω or 8Ω
1 x 240W @ 70V or 100V
Amplifier Type:
Class D
Maximum Voltage Gain:
26dB SE / 32dB BTL
Dynamic Range
119dB
Frequency Response
20Hz to 20kHz @ +/-1dB
S/N Ratio:
80dB -10dBV, 20 Hz - 20 kHz
Controls:
Screw trimmer amplifier attenuator, IP and RS-232
Audio THD + Noise:
THD+N (1kHz @ 1W) 0.003 %
Audio 2nd Harmonic:
0.08% @ 75W RMS @ 4Ω 6.67kHz
Power Source:
Universal mains operational voltage
85VAC – 265VAC
Universal mains operational voltage
85VAC – 265VAC )full power at 120V – 230V)
Total System Efficiency
89.2%
89.5%
Dimensions:
21.2cm x 22.8cm x 4.3cm (8.35" x 8.98" x 1.69") W, D, H
Weight:
1.0kg (2.2lbs) approx.
Included Accessories:
Power cord
Options:
RK-1 rack adapter
Specifications are subject to change without notice at www.kramerav.com