User manual

VS-88HDCPxl - Operating the VS-88HDCPxl 8x8 DVI Matrix Switcher

6.8 Resetting the Ethernet Configuration to Default Values

This procedure resets only the IP related parameters. All switching and

preset values remain unchanged.

To reset the IP parameters to their default values (see Section 8):

 Press and hold the ETH Reset button on the rear panel while powering up

the device

6.9 Controlling Configuration via the Ethernet Port

To control several units via Ethernet, connect the Master unit (Machine # 1)

Ethernet port on your PC. Use your PC to configure the initial settings (see

Section 5.1).

6.10 Firmware Upgrade

Instructions for upgrading the firmware can be found in the STC Firmware

Upgrade document.