Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Overview
- 4 Installing in a Rack
- 5 Connecting the VS-88HDCPxl
- 6 Operating the VS-88HDCPxl 8x8 DVI Matrix Switcher
- 7 Technical Specifications
- 8 Default Communication Parameters
- 9 Protocol 2000
VS-88HDCPxl - Connecting the VS-88HDCPxl
11
11
Figure 3: Connecting to the VS-88HDCPxl Rear Panel
5.1 Connecting to the VS-88HDCPxl via RS-232
You can connect to the VS-88HDCPxl via an RS-232 connection using, for
example, a PC. Note that a null-modem adapter/connection is not required.
To connect to the VS-88HDCPxl via RS-232:
Connect the RS-232 9-pin D-sub rear panel port on the VS-88HDCPxl unit
via a 9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin
5 need to be connected) to the RS-232 9-pin D-sub port on your PC