User manual
Your VS-88H 8x8 HDMI Matrix Switcher
7
Table 1: VS-88H 8x8 HDMI Matrix Switcher Front Panel Features
#
Feature
Function
1 IR Receiver The yellow LED lights when receiving signals from the Infrared remote
control transmitter
2 POWER LED Illuminates when the unit is turned ON
3 ALL Button Pressing ALL before pressing an input button, connects that input to
all outputs
1
4
OFF Button Pressing OFF after pressing an output button disconnects that output
from the inputs. To disconnect all the outputs,
press the ALL button and
then the OFF button
5 SELECT
Buttons
2
IN
Select the input to switch to the output (from 1 to 8)
6 OUT Select the output to which the input is switched (from 1 to 8)
7 STO Button Press to store the current settings
3
7.3 (see section )
8 RCL Button Press to recall the current settings
3
(see section 7.3)
9 LOCK Button Press and hold to toggle disengaging the front panel buttons and to
acquire the EDID
10 EDID Button Press EDID to capture the EDID (see section 7.2)
11 OUTPUT/ INPUT
7-segment LCD Display
Displays the selected input switched to the output (marked above
each input)
12 IN HDMI Connectors Connect to the HDMI sources (from 1 to 8)
13 OUT HDMI Connectors Connect to the HDMI acceptors (from 1 to 8)
14 RS-232 9-pin D-sub Port Connects to the PC or other RS-232 Remote Controller
15 ETHERNET Connector Connects to the PC or other Ethernet Controller
16 ETH RESET Button Press the ETHERNET factory reset button
to reset to the factory default
definitions
4
17
:
IP number − 192.168.1.39
Mask – 255.255.255.0
Gateway – 192.168.1.1
Power Connector with Fuse AC connector enabling power supply to the unit
18 Power Switch Illuminated switch for turning the unit ON or OFF
1 For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs
2 Are also used for storing machine setups (see section
7.3)
3 The input/output routing configuration is saved/recalled
4 First turn the VS-88H OFF and then turn it ON again while pressing the RESET button. The unit will power up and load its
memory with the factory default definitions