User manual

Operating the VS-88H 8x8 HDMI Matrix Switcher
KRAMER: SIMPLE CREATIVE TECHNOLOGY
12
4. Press the OFF button until a "0" (zero) appears on the display.
5. Press the EDID button.
The process is complete when the display returns to normal.
7.3 Storing and Recalling a Setting
You can use the STO and RCL buttons to store up to 16 setups and then
recall them.
To store a setting:
1. Set the machine to the desired setting.
For example, press the OUT 3 button and IN 4 button
1
2. Press the STO button.
The STO button flashes.
.
3. Select an OUT or IN SELECT button to store the machine setting (for
example, OUT 5).
4. Press the LOCK button
2
To recall a setup:
to store the current setup.
In this example, the OUT 5 button stores the setting.
1. Press the RCL button.
The RCL button flashes.
2. Press the relevant OUT or IN button that stored the setting.
In this example, press OUT 5.
3. Press the LOCK button to recall the stored setting.
7.4 Connecting to the VS-88H via RS-232
You can connect to the VS-88H via an RS-232 connection using, for
example, a PC. Note that a null-modem adapter/connection is not required.
To connect to the VS-88H via RS-232:
• Connect the RS-232 9-pin D-sub rear panel port on the VS-88H unit via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5
need to be connected) to the RS-232 9-pin D-sub port on your PC
1 You can set all the switcher IN-OUT buttons
2 You have to press the LOCK button within 10 seconds, before the store operation times out