Instruction Manual

VS-88DVI - Operating the VS-88DVI 15

6.4.3 Acquiring the Default EDID

To reset to the default EDID, do the following:

1. Turn ON the VS-88DVI.

2. Press the EDID and STO buttons simultaneously and hold them for 3

seconds.

Both buttons flash.

3. Press the SELECT IN button to which the EDID is copied.

The selected input number flashes on the display.

4. Press the OFF button until a "0" (zero) appears on the display.

5. Press the EDID button.

The process is complete when the display returns to normal.

6.5 Connecting the VS-88DVI Using RS-232

You can connect to the unit via a crossed RS-232 connection, using for example,

a PC. A crossed cable or null-modem is required as shown in method A and B

respectively. If a shielded cable is used, connect the shield to pin 5.

Method A (

Figure 5)—Connect the RS-232 9-pin D-sub port on the unit via a

crossed cable (only pin 2 to pin 3, pin 3 to pin 2, and pin 5 to pin 5 need be

connected) to the RS-232 9-pin D-sub port on the PC.

Note: There is no need to connect any other pins.

Figure 5: Crossed Cable RS-232 Connection

Hardware flow control is not required for this unit. In the rare case where a

controller requires hardware flow control, short pin 1 to 7 and 8, and pin 4 to 6 on

the controller side.