Instruction Manual

VS-88DVI - Operating the VS-88DVI 11
6 Operating the VS-88DVI
This section describes how to:
• Route inputs to outputs (see Section
6.1)
• Disconnect outputs (see Section
6.2)
• Store and recall a setup (see Section
6.3)
• Acquire the EDID (see Section
6.4)
• Control the machine via RS-232 (see Section
6.5)
• Control the machine via the Ethernet port (see Section
6.6)
6.1 Routing Inputs to Outputs
To route an input to an output:
• Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:
• Press ALL followed by an IN button. The input is routed to all outputs
6.2 Disconnecting the Outputs
To disconnect one output:
• Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:
• Press the ALL button and then press OFF. This disconnects all the outputs
6.3 Storing and Recalling a Setup
You can use the STO and RCL buttons to store up to 16 setups and then recall
them, as
Figure 4 illustrates:
IN 1 is used for setup # 1 and OUT 1 is used for setup # 9.