Instruction Manual

Operating Your Composite / s-Video / Audio Switcher
17
17
7.1.2 Selecting a CV or a Y/C Source on an Independent Unit
After connecting a composite video source to CV IN # 1 and an s-Video
(Y/C) source to Y/C video IN # 1, set the INPUT SETUP switch # 1, as
appropriate, before or after pressing the INPUT SELECTOR button # 1.
To select the CV source # 1:
• Pull the INPUT SETUP switch # 1 DOWN
• Press the INPUT SELECTOR button # 1
The INPUT SELECTOR button # 1 illuminates, indicating selection and
outputting
1
To select the Y/C source # 1, when the INPUT SELECTOR button # 1
illuminates:
of the video and audio CV source # 1
• Pull the INPUT SETUP switch # 1 UP
The INPUT SELECTOR button # 1 continues to illuminate, indicating
selection and outputting of the video and audio Y/C source # 1
To select the Y/C source # 1, when the INPUT SELECTOR button # 1 does
not illuminate:
• Pull the INPUT SETUP switch # 1 UP
• Press the INPUT SELECTOR button # 1
The INPUT SELECTOR button # 1 illuminates, indicating selection and
outputting of the video and audio Y/C source # 1
Figure 14: Selecting a CV or a Y/C Source
1 Figure 13 does not show any acceptor. Refer to Figure 16 and Figure 17 to see how to connect acceptors