Owner manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Overview
- 4 Defining the VS-808TP 8x8 Twisted Pair Matrix Switcher
- 5 Installing the VS-808TP in a Rack
- 6 Connecting the VS-808TP
- 7 Operating the VS-808TP Locally via the Front Panel Buttons
- 8 Operating the VS-808TP Remotely via the Web Pages
- 9 Technical Specifications
- 10 Default Parameters
- 11 Kramer Protocol
Figure 2 defines the rear panel of the VS-808TP.
Figure 2: VS-808TP 8x8 Twisted Pair Matrix Switcher Rear Panel
# Feature Function
8
AUDIO
Connectors
Unbalanced
IN 3.5mm mini jack Connect to the output of the unbalanced stereo audio source (for example, the audio output
of the laptop)
9 OUT 3.5mm mini jack Connect to the input of the unbalanced stereo audio acceptor (for example, the audio input of
the AV system)
10
Balanced
IN 5-pin terminal block Connect to the output of the balanced stereo audio source
11 OUT 5-pin terminal block Connect to the input of the balanced stereo audio acceptor
12 RS-485/RS-422 5-Pin Terminal Block Connect to the serial controller
13 RS-232 (DATA) 9-pin D-sub Connector Connect to the serial data source
14 ETHERNET RJ-45 Connector Connect via a LAN to the Ethernet port on the PC controller
15 INPUTS 1 ~ 8 RJ-45 Connectors Connect to the TP transmitters (for example, TP-133 or TP-125)
16 OUTPUTS 1 ~ 8 RJ-45 Connectors Connect to the TP receivers (for example, TP-134 or TP-126)
17 Chassis Ground Terminal Terminal for grounding the chassis to the common ground of the system
18
AC Mains Module
Mains socket Connect the mains power cord
19 Mains fuse holder Fuse for protecting the device
20 Mains switch Turn the device on and off
21 PC IN 15-pin HD VGA Connector Connect to the output of the VGA (up to WUXGA) source (for example, PC graphics card)
22 PC OUT 15-pin HD VGA Connector Connect to the input of the VGA acceptor (for example, LCD monitor)
23 RS-232 (CONTROL) 9-pin D-sub Connector Connect to the serial controller
VS-808TP – Defining the VS-808TP 8x8 Twisted Pair Matrix Switcher
5