Owner's manual
VS-6464DN DVI/HDCP I/O Card Installation Sheet
4. Remove the new card from its shipping box and anti-ESD bag.
5. Holding the card by the upper and lower handle, align the card
with the plastic guide rails.
6. Slide the card into the chassis until the front of the card makes
contact with the connector inside the chassis.
7. Press the card firmly into the slot until the connector plate is
flush with the rear panel of the chassis and the connector is
fully seated.
8. Using a Phillips screwdriver, tighten the retaining screws at the
top and bottom of the card to secure it to the chassis.
9. Power on the VS-6464DN and follow the procedure in the
VS-6464DN User Manual (see Section 9) to configure the new
card.
10. Power on the peripheral devices.
To install an I/O card:
1. Power off the VS-6464DN and all devices
connected to it.
2. Using a Phillips screwdriver, loosen the
screws at the top and bottom of the blanking
plate.
3. Remove the blanking plate from the slot and
store it for possible future use.
The VS-6464DN I/O Card mounts in one of the 16 slots on the rear of the VS-6464DN
chassis. Slots are numbered from left to right and must be filled consecutively from left to
right, without leaving empty slots.
VS-6464DN DVI/HDCP
I/O Card Installation Sheet
(P/N: 2900-300233 REV 1)
O
U
T
D
V
I
9~16
17~24
25~32
9~16
17~24
25~32
33~40
41~48
49~56
57~64
33~40
41~48
49~56
57~64
1~8
1~8
CT
RL
PATTER N R ESOLUT ION
DV
I
D
V
I
DV
I
DV
I
DV
I
DVI
DV
I
DVI
DV
I
D
V
I
D
V
I
D
VI
D
V
I
D
V
I
DVI
D
V
I
C
T
R
L
O
U
T
D
V
I
Kramer Electronics Ltd.
1
P/N:
Rev:
2900- 300233
WARNING: An input card must be mounted
only in a slot designated for input cards (slots 1
to 4 and 9 to 12) and an output card must be
mounted only in a slot designated for output
cards (slots 5 to 8 and 13 to 16).