Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Contents
ii
8.2 Using the Config Menu 26
8.2.1 Config Menu—Input Signal Detection Display 27
8.2.2 Config Menu—Output Load Detection Display 27
8.2.3 Config Menu—Interface Configuration 28
8.2.4 Config Menu—Interface Reply Configuration 28
8.2.5 Config Menu—Protocol Configuration 29
8.2.6 Config Menu—Store Default Setup 29
8.2.7 Config Menu—Total Matrix Reset 30
8.2.8 Config Menu—Display Firmware Versions 31
9 Configuring the Number of Installed Input and Output Ports 31
10 Using the Video Generator to Troubleshoot Video Problems 32
10.1 Installing the Video Generator 32
10.2 Setting the Resolution of the Generated Video 32
10.3 Setting the Pattern of the Generated Video 33
10.4 Using the Video Generator to Troubleshoot Video Problems 33
10.4.1 Testing the Projector Output 34
10.4.2 Testing the Output Signal Path to the Projector 34
10.4.3 Testing the Input and Output Signal Path to the Projector 34
11 I/O Card Hardware Installation Instructions 35
12 Power Supply Installation 37
13 Upgrading the VS-6464DN Firmware 37
14 Technical Specifications 37
15 Default Communication Parameters 39
16 Factory Default EDID 39
16.1 DVI Input Card 39
16.2 DVI (HDCP) Input Card 40
17 Communication Protocols 42
Figures
Figure 1: VS-6464DN 64x64 Digital Matrix Switcher Front Panel 6
Figure 2: VS-6464DN
Front Panel Numeric Keypad 7
Figure 3: VS-6464DN 64x64 Digital Matrix Switcher Rear Panel Showing DVI Cards 8
Figure 4: Connecting the VS-6464DN
11
Figure 5: Sample Port Numbering 13
Figure 6: Local Area Connection Properties Window 15
Figure 7: Internet Protocol (TCP/IP) Properties Window 16
Figure 8: Default Startup Status Display Sequence 17
Figure 9: Resolution DIP-switch 33
Figure 10: Signal Paths for Isolating problems 34
Figure 11: Inserting the Card into a Slot 35
Figure 12: Card Handles 36