Owner's manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VS-44HC
24
8.4 Confirming Settings
You can choose to work in the At Once or the Confirm mode.
In the At Once mode (TAKE button is not illuminated):
 Pressing an OUT-IN combination implements the switch immediately
 You save time as execution is immediate and actions require no user
confirmation
 No protection is offered to correct an erroneous action
In the Confirm mode (TAKE button is lit):
 You can key-in an action and then confirm it by pressing the TAKE
button
 Every action requires user confirmation, protecting against erroneous
switching
 Execution is delayed until the user confirms the action
1
8.4.1 Toggling between the At Once and Confirm Modes
To toggle between the At Once and Confirm modes, do the following:
1. Press the TAKE button to toggle between the At Once mode (in which the
TAKE button is not lit) and the Confirm mode (in which the TAKE button
illuminates).
Actions now require user confirmation and the TAKE button illuminates.
2. Press the illuminated TAKE button to toggle from the Confirm mode back to
the At Once mode.
Actions no longer require user confirmation and the TAKE button no longer
illuminates.
8.4.2 Confirming a Switching Action
To confirm a switching action (in the Confirm mode), do the following:
1. Press an OUT-IN combination.
The corresponding 7-segment display blinks. The TAKE button also blinks.
2. Press the blinking TAKE button to confirm the action.
The corresponding 7-segment display no longer blinks. The TAKE button
illuminates.
1 Failure to press the TAKE button within one minute (the Timeout) will abort the action