User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Operating the VS-44H 4 x 4 HDMI Matrix Switcher

7.4.4 Acquiring the Default EDID

To reset to the default EDID, do the following:

1. Turn ON the VS-44H.

2. Press the EDID and STO buttons simultaneously and hold them for 3

seconds.

Both buttons flash.

3. Press the SELECT IN button to which the EDID will be copied.

The selected input number flashes on the display.

4. Press the OFF button until a "0" (zero) appears on the display.

5. Press the EDID button.

The process is complete when the display returns to normal.

7.5 Connecting to VS-44H via RS-232

You can connect to the VS-44H via an RS-232 connection using, for

example, a PC. Note that a null-modem adapter/connection is not required.

To connect to the VS-44H via RS-232:

• Connect the RS-232 9-pin D-sub rear panel port on the VS-44H unit via a

9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5

need to be connected) to the RS-232 9-pin D-sub port on your PC

7.6 Controlling via ETHERNET

You can connect the VS-44H via the Ethernet, using a crossover cable (see

section

7.6.1) for direct connection to the PC or a straight-through cable

(see section

7.6.2) for connection via a network hub or network router

7.6.1 Connecting the ETHERNET Port directly to a PC (Crossover Cable)

You can connect the Ethernet port of the VS-44H to the Ethernet port on

your PC, via a crossover cable with RJ-45 connectors.

This type of connection is recommended for identification of the factory default

IP Address of the VS-44H during the initial configuration

1 After connecting the Ethernet port, you have to install and configure your Ethernet Port. For detailed instructions, see the

“Ethernet Configuration (FC-11) guide.pdf” file in the technical support section on our Web site:

http://www.kramerelectronics.com