User Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your Video Matrix Switcher
6
Table 1: Front Panel VS-3232V 32x32 Video Matrix Switcher Features
# Feature Function
1 ESC Press to exit the current operation
2 STO
1
Press to store the current setting in the non-volatile memory
3 ALL
1
Press ALL followed by an input number to connect that input to all the
outputs
4 OFF
1
Press OFF followed by an output number to disconnect that output
5 RCL
1
Press to recall a setup from the non-volatile memory
6
Menu Buttons
ENT Press to complete the input-output setup when using a one-digit number
instead of two digits
2
.
Press to enter the options in a setup menu
7  (Forward) Press to shift the content of the display to the left
3
8  (Backward) Press to shift the content of the display to the right
3
9
Double-function Selector Buttons Area
Button
Labels
Digits from
0 to 9
Select the output to which the input is switched and select the input to
switch to the output
10 FOLLOW Button Press to enter the Follow mode in the multi-switcher configuration
11 BREAKAWAY Button Press to enter the Stand-Alone mode in the multi-switcher configuration
12 DEFAULT SETUP Button Press to recall the default setup (UNITY setting), see section 8.5
13 INPUTS/OUTPUTS LCD
Display
Displays the outputs (in the upper row, below the OUTPUTS label)
switched to the selected inputs (in the lower row, above the INPUTS
label).
Displays user interface messages and configuration menu items
14 LOCK Button Toggle
4
to lock/unlock the front panel buttons
15 MENU Button Press once to enable the ALL, OFF STO and RCL buttons
Press twice to enter the configuration menu
When in the configuration menu, press to browse through the menu items
16 TAKE Button Used to confirm and complete setup and switching
17 Power Switch Illuminated switch for turning the unit ON or OFF
18 IR Receiver The red LED is illuminated when receiving signals from the Kramer Infra-
red remote control transmitter
1 This button is enabled and illuminated after pressing the MENU button
2 For example, to enter input 5, you can either press 0, 5 or 5, ENT
3 Since the LCD display is large enough to show only 13 cross-points out of a total of 32
4 Press and hold the LOCK button for about two seconds to toggle