Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your VS-162AVM
30
2 flashing digits and the TAKE LED flashes.
The STATUS display shows
1
out # x
reset
the message:
Where x is the output number
3. Press the TAKE button to confirm the action.
The input is cleared and the TAKE LED lights. The MATRIX display does
not show any Input # in its place.
10.7.2 Clearing Several Outputs
To clear several outputs (in the AT ONCE mode):
1. Press the appropriate OUT button.
The MATRIX display shows the 2 flashing digits, representing the present
input number for that specific output
2
out # x
. If the present output is clear, the 2
flashing digits 00 appear in the MATRIX display.
The STATUS display shows the message:
Where x is the output number
2. Press the OFF button.
The output is cleared and the MATRIX display does not show any Input #
in its place.
The STATUS display momentarily shows the message:
out # x
reset
Where x is the output number
To clear several outputs (in the CONFIRM mode (the TAKE LED is lit)):
1. Repeat step 1 above.
2. Press the OFF button.
The MATRIX display shows the 2 flashing digits 00 instead of the previous
2 flashing digits and the TAKE LED flashes.
The STATUS display shows
1
the message:
out # x
reset
1 Continuously, within the limit of the timeout (approximately 30 seconds)
2 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9