Manual

Operating Your VS-162AVM
27
27
Where x is the output number
2. Press the appropriate IN button.
The output switches to the input and the MATRIX display shows the Input
# instead of the flashing digits.
The STATUS display momentarily shows the message:
out # x
from in # y
Where x is the output number and y is the input number
Pressing an OUT-IN combination when your unit operates in the
CONFIRM mode (and the TAKE LED is lit), requires user confirmation.
To switch one input to one output (CONFIRM mode):
1. Repeat step 1 above.
2. Press the appropriate IN button.
The MATRIX display shows the 2 flashing digits, representing the input
number and the TAKE LED flashes.
The STATUS display shows
1
out # x
from in # y
the message:
Where x is the output number and y is the input number
3. Press the TAKE button to confirm the action.
The output switches to the input and the TAKE LED lights.
10.6.2 Switching Several Inputs to Several Outputs
In the AT ONCE mode, you need to execute each OUT-IN combination
separately (see section
10.6.1). When switching many inputs to many
outputs it is recommended to toggle to the CONFIRM mode.
In the CONFIRM mode you can key-in several actions and then confirm
them by pressing the TAKE button once (simultaneously switching several
inputs to several outputs).
To switch several inputs to several outputs in the CONFIRM mode (the
TAKE LED is lit), do the following:
1. Press the appropriate OUT button.
The MATRIX display shows the 2 flashing digits, representing the previous
input number for that specific output
2
1 Continuously, within the limit of the timeout (approximately 30 seconds)
. If the previous input is clear, the 2
2 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9