Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Installing and Operating a Single VS-162AVM
10
6 Installing and Operating a Single VS-162AVM
To install the VS-162AVM, connect the following
1
• Video input and output cables
to the rear panel, as
required:
• Audio input and output cables
• Control interface cables between switcher units, or PC (or other
controller), as section
9 describes
• Set the DIP-switches, as section
8.1 describes
• Power cord
• Set the system variables using the MENU function, as section
11
describes
By default, the VS-162AVM is setup for use as a single machine. This
means that it is:
• A 16x16 composite video switcher and a 16x16 balanced stereo
audio switcher are set to function by default, in the audio-follow-
video mode
• Switched during the vertical interval of the external reference
In particular, be sure that the DIP-switches are set as
Figure 2 illustrates
(see section
8.1 for further details):
Figure 2: Default DIP-Switch Setup on a Single Machine
To operate a single machine, see Table 3.
1 Switch OFF the power on each device before connecting it to your unit